Nuclear Engineering & Customised Staff Augmentation
FreNuc engineering and customized staff augmentation services involve engineering support under Nuclear QA Program on and off-site in various areas. Most of the analysis scope of work is done using CAT I software such as ANSYS.
Customised Staff Augmentation
FreNuc customised staff augmentation services provide qualified and experienced personnel for on of off-site resource management towards project control and cost containment.
FreNuc staff is:
- Trained under Nuclear QA Program
- Aware of and understands the requirements of performing
safety-related calculations per Appendix B requirements
- Trained specifically to understand client polices, procedures and
formats to minimize human errors
Aeras of Engineering Support
Mechanical
- Finite element Analysis
- Dynamic Analysis (Seismic)
- Environmental Qualification and Testing
- Commercial grade dedication of equipment and embedded software
Structural
- Structural Analysis
- Piping design and hanger support
- Steel detailing
- Plant design including civil and structural input involving piping and
piping supports
- Eyuipment modelling and floor penetration details
Electrical
- Preparation of design basis report
- Sizing of power and distriburion transformer and emergency diesel
generator, overall single line diagram of plant with protection and
metering requirements
- Power control center, MCC and plant switch yard
- Sizing and preparation of technical specification for procurement of
electrical 11 kV & 33 kV panels, MCC transformers, DC Equipment,
HT/LT cable sizing and scheduling
- Preparation of control schematic and layout drawings to facilitate
electrical erection
- Project management, erection, commissioning
Instrumentation
- Preparation of pre-bid technical specification for plant instrumentation
and DCS or PLC system, bill of quantities with estimated cost
- Basic engineering of plant DCS or PLC system including DCS/PLC
signal input/output, system architecture
- Detail engineering of plant instrumentation including instruments list,
control valve list, pneumatic actuators, instrumentation data sheet,
field instrument erection, location, signal cable routing
- Erection and commissioning of plant instrumentation including
calibration of field instrurments, control valves actuators and PLC
systems